How to open Ardo washing machine top cover

In most cases, you can repair an Ardo washing machine yourself, without calling a specialist. To do this, you need to have a general idea of ​​the device, know where which units are located, what this or that element is responsible for. To get to the right part and perform repairs, you will have to partially disassemble the case. Let's figure out how to remove the top cover of the washing machine, what tools are needed for this.

Removal in three movements

In fact, it is very easy to “open” the washing machine. In the process of removing the “top”, you will only need a screwdriver or a regular screwdriver. Before disassembling the case, be sure to de-energize the equipment and turn off the water supply tap. Next, you need to move the equipment away from the wall, so it will be more convenient to work. Now nothing interferes with dismantling the top cover of the Ardo washing machine. The algorithm of actions is as follows:

• Go around the washing machine,
• Unscrew the two screws that hold the "top" of the case. The bolts are located under a small ledge, in the right and left corners,
• Grab the top panel and pull it towards you. The cover should move literally a couple of centimetres,
• Remove the lid and set aside.

At this point, the process of removing the top panel will be completed. You can proceed to diagnosing the Ardo washing machine and the necessary repairs.

When the "top" does not move from its place, the panel is probably jammed. You will have to "shake" it up by pressing on the cover from different sides. It is permissible to tap it lightly with a mallet. It is important not to overdo it and not to damage the case. This is how you can remove the top cover on Ardo washing machines. Using this algorithm, it is easy to open many modern models of other brands - the principle of dismantling remains unchanged.

What kind of repair is this needed for?

If you want to service and repair your "home assistant" with your own hands, you will have to understand how to disassemble its "shell". The need to remove the top cover arises with almost any breakdown of the automatic machine. We will tell you which parts and units can be repaired or replaced if you dismantle this panel of the case.

After disconnecting the "top", access to the inlet solenoid valve will open. It is necessary to check the part if water does not enter the machine, or too much liquid is poured in. The element is located in the right corner, next to the back panel. By removing the cover, you can test the coil and other parts of the mechanism. The sensor can also be completely replaced, if necessary. If the powder is poorly washed out of the detergent tray, it is worth checking the dispenser pipe. By removing the "top" in the described way, you can clean the tube. It will also be easy to replace the part if necessary.

Another element located under the top panel is the pressure switch. The level sensor measures the amount of water in the tank, sends a signal to the “brain” when it is time to start or finish filling the tank with liquid or drain the soap solution. By removing the cover, it is easy to check the serviceability of the element and replace it if necessary. There is a counterweight under the cover. This is a concrete block that ensures the stability of the Ardo washing machine. This part breaks extremely rarely, but if the weight is damaged, it can also be repaired by removing the “top”.

Removing the cover is necessary if you need to get the tank. However, in such a situation you will have to not only remove the "top", but also the back panel, the front wall, disconnect many internal parts from the plastic container: heating element, engine, drain pump, pipes, etc. However, the disassembly procedure begins with the top part. Therefore, the ability to remove the "top" of the case will be useful to users in many situations. This is a kind of starting point for repairs of varying complexity.